Magnesium hydroxide is the inorganic compound with the chemical formula Mg(OH)2. It occurs in nature as the mineral brucite. It is a white solid with low solubility in water (Ksp = 5.61×10-12). Magnesium hydroxide is a common component of antacids, such as milk of magnesia, as well as laxatives.
Maps, Directions, and Place Reviews
Preparation
Combining a solution of many magnesium salts with alkaline water induces precipitation of solid Mg(OH)2:
On a commercial scale, Mg(OH)2 is produced by treating seawater with lime (Ca(OH)2). 600 m3 of seawater gives about one ton of Mg(OH)2. Ca(OH)2 is far more soluble than Mg(OH)2, the latter precipitates as a solid:
Uses
Precursor to MgO
Most Mg(OH)2 that is produced industrially, as well as the small amount that is mined, is converted to fused magnesia (MgO). Magnesia is valuable because it is both a poor electrical conductor and an excellent thermal conductor.
Health
Metabolism
When the patient drinks magnesium hydroxide, the suspension enters the stomach. Depending on how much was taken, one of two possible outcomes will occur.
As an antacid, magnesium hydroxide is dosed at approximately 0.5-1.5 g in adults and works by simple neutralization, where the hydroxide ions from the Mg(OH)2 combine with acidic H+ ions produced in the form of hydrochloric acid by parietal cells in the stomach to produce water.
As a laxative, magnesium hydroxide is dosed at 2-5 g, and works in a number of ways. First, Mg2+ is poorly absorbed from the intestinal tract, so it draws water from the surrounding tissue by osmosis. Not only does this increase in water content soften the feces, it also increases the volume of feces in the intestine (intraluminal volume) which naturally stimulates intestinal motility. Furthermore, Mg2+ ions cause the release of cholecystokinin (CCK), which results in intraluminal accumulation of water, electrolytes, and increased intestinal motility. Although it has been stated in some sources, the hydroxide ions themselves do not play a significant role in the laxative effects of milk of magnesia, as basic solutions (i.e., solutions of hydroxide ions) are not strongly laxative, and non-basic Mg2+ solutions, like MgSO4, are equally strong laxatives mole for mole.
Only a small amount of the magnesium from magnesium hydroxide is usually absorbed by the intestine (unless they are deficient in magnesium). However, magnesium is mainly excreted by the kidneys so long-term, daily consumption of milk of magnesia by someone suffering from renal failure could lead in theory to hypermagnesemia. Unabsorbed drug is excreted in feces; absorbed drug is excreted rapidly in urine.
History of milk of magnesia
On May 4, 1818, American inventor John Callen received a patent (No. X2952) for magnesium hydroxide. In 1829, Sir James Murray used a "condensed solution of fluid magnesia" preparation of his own design to treat the Lord Lieutenant of Ireland, the Marquis of Anglesey, of stomach pain. This was so successful (advertised in Australia and approved by the Royal College of Surgeons in 1838) that he was appointed resident physician to Anglesey and two subsequent Lords Lieutenant, and knighted. His fluid magnesia product was patented two years after his death in 1873.
The term milk of magnesia was first used by Charles Henry Phillips in 1872 for a suspension of magnesium hydroxide formulated at about 8%w/v. It was sold under the brand name Phillips' Milk of Magnesia for medicinal usage.
Although the name may at some point have been owned by GlaxoSmithKline, USPTO registrations show "Milk of Magnesia" and "Phillips' Milk of Magnesia" have both been assigned to Bayer since 1995. In the UK, the non-brand (generic) name of "Milk of Magnesia" and "Phillips' Milk of Magnesia" is "Cream of Magnesia" (Magnesium Hydroxide Mixture, BP).
Magnesium hydroxide is marketed for medical use as chewable tablets, as capsules, and as liquid suspensions, sometimes having various flavors added. These products are sold as antacids to neutralize stomach acid and relieve indigestion and heartburn. It also is a laxative to alleviate constipation. As a laxative, the osmotic force of the magnesia acts to draw fluids from the body. High doses can lead to diarrhea, and can deplete the body's supply of potassium, sometimes leading to muscle cramps.
Some magnesium hydroxide products sold for antacid use (such as Maalox) are formulated to minimize unwanted laxative effects through the inclusion of aluminum hydroxide, which inhibits the contractions of smooth muscle cells in the gastrointestinal tract, thereby counterbalancing the contractions induced by the osmotic effects of the magnesium hydroxide.
Magnesium hydroxide is also a component of antiperspirant. Magnesium hydroxide is useful against canker sores (aphthous ulcer) when used topically.
Other niche uses
Waste water treatment
Magnesium hydroxide powder is used industrially to neutralize acidic wastewaters. It also takes part in the Biorock method of building artificial reefs.
Fire retardant
Natural magnesium hydroxide (brucite) is used commercially as a fire retardant. Most industrially used magnesium hydroxide is produced synthetically. Like aluminium hydroxide, solid magnesium hydroxide has smoke suppressing and flame retardant properties. This property is attributable to the endothermic decomposition it undergoes at 332 °C (630 °F):
The heat absorbed by the reaction retards the fire by delaying ignition of the associated substance. The water released dilutes combustible gases. Common uses of magnesium hydroxide as a flame retardant include additives to cable insulation (i.e. cables for high quality cars, submarines, the Airbus A380, the Playstation 4, etc.), insulation plastics, roofing (e.g. London Olympic Stadium), and various flame retardant coatings. Other mineral mixtures that are used in similar fire retardant applications are natural mixtures of huntite and hydromagnesite.
Mineralogy
Brucite, the mineral form of Mg(OH)2 commonly found in nature also occurs in the 1:2:1 clay minerals amongst others, in chlorite, in which it occupies the interlayer position normally filled by monovalent and divalent cations such as Na+, K+, Mg2+ and Ca2+. As a consequence, chlorite interlayers are cemented by brucite and cannot swell nor shrink.
Brucite, in which some of the Mg2+ cations have been substituted by Al3+ cations, becomes positively charged and constitutes the main basis of layered double hydroxide (LDH). LDH minerals as hydrotalcite are powerful anion sorbents but are relatively rare in nature.
Brucite may also crystallise in cement and concrete in contact with seawater. Indeed, the Mg2+ cation is the second most abundant cation in seawater, just behind Na+ and before Ca2+. Because brucite is a swelling mineral, it causes a local volumetric expansion responsible for tensile stress in concrete. This leads to the formation of cracks and fissures in concrete, accelerating its degradation in seawater.
For the same reason, dolostone cannot be used as construction aggregate for making concrete. The reaction of magnesium carbonate with the free alkali hydroxides present in the cement porewater also leads to the formation of expansive brucite.
This reaction, one of the two main alkali-aggregate reaction (AAR) is also known as alkali-carbonate reaction.
Source of the article : Wikipedia
EmoticonEmoticon